Loading...
 Start Page
  • The roller assembly consists of tube, end cups, shaft, ball bearings and labyrinth type seals.
  • The end cups are manufactured on our premises made off deep drawn steel sheet, with a calibrated ball-bearing seat, so that they are concentric and correctly sized to suit the selected bearings.
  • The shaft is made of cold drawn steel bars (tolerance h9).
  • The ball-bearings are according to ABEC 1, chrome steel GCr15, C3 clearance, lithium greased, lubrication >30%...=40%
  • The bearings are protected against dust and water penetration by highly sophisticated labyrinth seal system with an external zinc coated outer seal.
  • Rollers standard finishing process: spray painting with two component epoxy or polyurethane coating and hot galvanizing.
  • Rollers have very low starting and rolling resistance which allows low energy consumption.
  • General fabrication tolerances for shafts : ±0.2 mm
  • General fabrication tolerances for steel shell length : ±1.5 mm
  • Max allowed movement of the shaft in roller with axial force 500N : 0.7mm
  • Rollers have low Total Indicated Run Out (TIR) tolerance in order to reduce noise emissions.

 

Download our brochures from here:

 Agias Lavras, Vernadeika, 26504, Patras, Greece

  +30.2610.991480, +30.2610.991481, +30.2610.991541

  +30.2610.992412   //     info@zikosmetal.com

Login / Sitemap

© Copyright 2019 - 2024 ZIKOS METALLURGY S.A. - Rollers | Idlers | Pulleys - Patras, Greece